Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Evanston, WY

Garaga Garage Door Cable Repair in Evanston, WY

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

Need Garaga garage door cable repair in Evanston, WY? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Frayed, snapped or slipped lift cables replaced and the door re-leveled. We work on Garaga garage doors of every age, from older models to current lines, and carry or can source compatible parts. Garaga is a Canadian garage door manufacturer based in Quebec.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for Garaga garage door cable repair?

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

What usually causes it

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

What you can check yourself

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Garaga garage door cable repair

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

Typical Garaga garage door cable repair prices

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Garaga services

Local Garaga garage door cable repair for Evanston, WY

Large daily temperature swings in Wyoming work hinge screws and track bolts loose, which leads to noise, wobble and eventually an off-track door.

Technicians serve all of Evanston (ZIP codes 82930 and 82931), plus Lyman (35 mi), Morgan, UT (40.4 mi), Kemmerer (42.4 mi) and Mountain Green, UT (43.9 mi). Call (833) 435-8883 to book a visit in Evanston.

Garaga Garage Door Cable Repair: frequently asked questions

How much does Garaga garage door cable repair cost in Evanston, WY?

Garaga Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Garaga garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Garaga garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Garaga warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Wyoming or Evanston requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Evanston, WY

Overhead Door Garage Door Opener Installation

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $350-$800

Genie Garage Door Opener Installation

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $350-$800

Windsor Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Commercial Overhead Door Installation

Commercial sectional, insulated and high-cycle doors and operators installed.

Typical $2,500-$12,000

Raynor Garage Door Panel Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $300-$900

Ideal Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Sommer Garage Door Opener Installation

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $350-$800

Richards-Wilcox Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

CHI Overhead Doors Off-Track Garage Door Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $175-$450

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Garage door stuck, noisy or broken?

Talk to a garage door technician in Evanston, WY now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote